Show simple item record

dc.contributor.authorPramanik, Alokesh
dc.contributor.authorSoon, Neo
dc.contributor.authorRahman, Mustafizure
dc.contributor.authorLi, X
dc.contributor.authorSawa, M
dc.contributor.authorMeada, Y
dc.date.accessioned2017-01-30T13:54:20Z
dc.date.available2017-01-30T13:54:20Z
dc.date.created2013-02-12T20:00:23Z
dc.date.issued2003
dc.identifier.citationPramanik, A. and Neo, K. S. and Rahman, M. and Li, X. P. and Sawa, M. and Meada, Y. 2003. Cutting performance of diamond tools during ultra–precision turning of electroless nickel plated die materials. Journal of Materials Processing Technology. 140 (1-3): pp. 308-313.
dc.identifier.urihttp://hdl.handle.net/20.500.11937/36209
dc.identifier.doi10.1016/S0924-0136(03)00751-9
dc.description.abstract

This study is an attempt (a) to observe the wear characteristic of diamond tool with 200 km cutting distance and to study the effects of wear on the surface roughness and cutting forces and (b) to optimize various cutting parameters such as depth of cut, feed rate, spindle speed and phosphorus content. The experimental results showed that tool wear was not so significant although some defects on rake face were observed after cutting 15.6 km. Further cutting showed that the surface roughness increases with cutting distance, and that the cutting forces were larger than thrust force at the beginning of cutting, but after cutting 130 km, thrust force became larger and increased rapidly. It was also observed that forces increase with the increase of depth of cut, spindle speed and feed rate, and decrease with the increase of phosphorus content of the plating. Depth of cut has no significant effect on surface roughness, while it increases with increase of feed rate and decreases with the increase of percentage of phosphorus content in the workpieces. In case of spindle speed, surface roughness decreases with the increase of spindle speed up to a certain value and then starts to increase with the increase of spindle speed.

dc.publisherElsevier SA
dc.subjectElectroless-nickel
dc.subjectUltra-precision machining
dc.subjectTool wear
dc.subjectDiamond turning
dc.titleCutting performance of diamond tools during ultra–precision turning of electroless nickel plated die materials
dc.typeJournal Article
dcterms.source.volume140
dcterms.source.startPage308
dcterms.source.endPage313
dcterms.source.issn09240136
dcterms.source.titleJournal of Materials Processing Technology
curtin.note

NOTICE: this is the author’s version of a work that was accepted for publication in Journal of Materials Processing Technology. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Journal of Materials Processing Technology, Volume 140, Issues 1-3, September 2003, DOI:10.1016/S0924-0136(03)00751-9

curtin.department
curtin.accessStatusOpen access


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record